Precision-Engraved. Infinitely Yours.

Handmade in the Netherlands,
built for the next 18 holes and the next generation.

I started this to show my son that nothing in golf has to go to waste.

DimpleMark began as a father's project: a way to prove that the balls we lose in the rough and the water don't have to end their story there. I pull them out myself here in the Netherlands, assemble each one by hand, and pair them with plant-based 3D printing to turn them into precision marking tools built to last.

Every Dimple¹ is assembled by hand, in small batches, in my own workshop in the Netherlands. No factory, no mass production, just me starting from a real recycled ball every time. To keep the course as good for his generation as it was for mine, 10% of every sale goes straight to Schone Rivieren, pulling plastic out of Dutch rivers before it ever reaches the water.

Dad, founder, and still looking for his ball in the rough.

Built from what golf
already left behind.

Every material choice serves the same idea: nothing here should have to be new to be exceptional.

Exploded View

Repurposed Heritage

A handle with a story.

Every core begins as a genuine golf ball, recovered from water hazards and rough. Its dimples, scuffs, and history make each handle one-of-a-kind: a 42.7mm grip that fits the palm the way only a real ball can.

Bio-Based Engineering, Handmade in Holland

Grown, not drilled. Assembled by hand, not in a factory.

The housing is 3D-printed from PLA, a biopolymer derived from corn and sugarcane starch, grown layer by layer instead of molded or machined. No overseas factory, no outsourcing: every Dimple¹ is printed, assembled, and checked by hand, in small batches, in my own workshop in the Netherlands.

Refillable Longevity

Built to outlast the box.

A vapor-locked, friction-fit cap keeps solvent ink fresh for seasons. When it runs low, a 3ml dropper refill brings it back in seconds. No replacement, ever.

Uncap. Press. Done.

No setup, no mess: just a crisp, permanent mark in the time it takes to tee up.

1

Uncap the base

Remove the vapor-locked cap to expose the pre-inked flash foam face, ready on contact with no priming needed.

2

Press onto the ball

The rescued golf-ball handle sits naturally in your palm. Press down firmly onto any standard ball.

3

Instant dry mark

Solvent ink bonds to urethane and ionomer covers in under 15 seconds, smudge-proof through sand, water, and impact.

Not a craft project.
A precision instrument.

Held up against the alternatives, the gap isn't subtle.

If you can draw it,
I'll cut it.

There's no template, no preset library, no "pick one of these." Every die is custom-cut from scratch: initials, a crest, a wordmark, a doodle, an inside joke. If you can imagine it, it's fair game. Nothing about your Dimple¹ ships the same as anyone else's.

Initials

Make it unmistakably yours.

Symbol / Crest

Wear your own mark.

Wordmark

Course, club, or crew.

The three above are just a starting point, not the limit. Submit any design at checkout, however detailed, however weird, and I'll cut a die to match it exactly, then pair it with your rescued handle before it ships.

Recycled on the outside.
A promise on the inside.

Dimple¹ ships in a slim sleeve pressed from recycled paper, no plastic window, no foam insert, nothing here that outlives the stamp itself. A single die-cut opening frames the ball inside, so the first thing you see is the handle it was made from.

And the first ball you ever mark with it? That one's on me. I tuck a lake ball I pulled out myself right into the sleeve alongside your stamp, so the first press is yours to make, not mine.

One rescued ball, one first impression, yours to make.